How to Replace Rear Disc Brakes in a Ford Mustang

Replacing the rear disc brakes on a Ford Mustang requires a special tool, Rear Caliper Piston Adjuster 206-026, to seat the piston. Purchase this tool at your Ford dealership in the parts department. With this special tool and these instructions, you are ready to replace the rear disc brakes in your Mustang.

Instructions

1

Siphon half of the brake fluid from the master cylinder reservoir and put it in an approved container. Take the brake fluid to your local auto parts store for proper disposal.

2

Raise the vehicle off the ground using a car jack. Loosen the lug nuts with a torque wrench and remove the wheels.

3

Disconnect the rear disc brake caliper and hang it from the body of the Mustang with wire. Take out the inner and outer rear disc brake pads along with the spring clips.

4

Seat the piston by rotating it clockwise using the Rear Caliper Piston Adjuster 206-026. Replace the disc brake pads and spring clips with the new ones.

5

Line up the notch in the caliper piston with the alignment pin on the brake pad. Mount the rear disc brake caliper and use the torque wrench to tighten it to 24 ft. lb.

6

Replace the wheels and lower the Mustang to the ground. Position the new rear disc brake pads by pumping the brake pedal rapidly. Refill the master cylinder reservoir with clean brake fluid.

Related Posts by Categories